Vans Aircraft RV-12 Airplane Build, Sections 44A: Autopilot Servos (part 1)

Reference: pages 44A-02; 1.5 hours

Step 1: Cut the F-1291 Roll Servo Pushrod and the F-1292 Pitch Servo Pushrod from AT6-058X5/16 Tube. Drill and tap the ends of each pushrod. See figure 1 on page 44A-02 for the drill and tap size.



Step 2: Assemble the F-1291 Roll Servo Pushrod and hardware as shown in Figure 2 to make the Roll Servo Pushrod Assembly.


Step 3: Assemble the F-1292 Pitch Servo Pushrod and hardware as shown in Figure 3 to make the Pitch Servo Pushrod Assembly.



Steps 4 & 5: These are NA as they deal with removing the seat ramp cover and bulkhead covers. These have not installed.

This completes this entry and fabrication of the two Servo push rods.