Vans Aircraft RV-12 Airplane Build, Section 31A: Wing Electrical Interconnector Update (part 5)

Reference: Pages 31A-04, 31A-05; 6.0 hours

Again I find myself working on the wing lighting wiring for the RV-12 airplane.

Reference: Page 31A-04

Step 8: On the left wing use the string previously installed to pull the Strobe Power Wire, Strobe synch Wire, and another string from the wing root into the wing tip. Repeat on the other wing.





Step 9: Attach all the crimped wires called out in Figure 1 on page 31A-05 to the Floating 8 Pos Connector Male. On the back side of the connector is a number for the wire position.

Step 10: Attach all the crimped wires called out in Figure 2 on page 31A-05 of the RV-12 airplane plans to the Floating 8 Pos. Connector Female.



This completes page 31A-04.

Reference: Page 31A-05>br/>
Step 1: On the left wing attach the ring terminal end of the Terminal Ground Wire to the Nose Rib and then repeat for the right wing.

Step 2: Install the Floating 8 Pos Connector Male and Female to the Standoffs.





This completes page 31A-05 and this work session on the RV-12 airplane.